EINHELL Bavaria BPM 500 Instructions De Service page 5

Spread the polishing
paste evenly over
the polishing pad. Do
not apply the polish
directly to the polis-
hing surface.
Switch the polis-
hing machine on
and off only when
the polishing
machine is resting
on the polishing
surface.
Place the extension lead over your shoulder and
work first on the large, flat surfaces such as the
bonnet, boot lid and roof, keeping your movements
as regular as possible.
Important! Allow the polishing machine to glide over
the polishing surface. Do not exert pressure!
Work next on the
smaller surfaces
(doors, for example).
Allow the mains
cable to hang from
the appliance and
hold the polishing
machine as
illustrated.
For less accessible
areas (such as
wing-mirrors,
bumpers and door
handles etc.),
remove the
polishing cap from
the pad and polish
these areas by hand.
Now replace the
textile polishing cap
with the fine polis-
hing cap and pull
this over the polis-
hing pad. Make sure
it is completely
clean. Remove the
layer of polish in the
same order as it was
applied. Important!
Do not exert pres-
sure on the
polishing machine!
6. Disposal
The tool, accessories and packaging should be dis-
posed of in an environmentally-friendly fashion.
Plastic parts are coded for purposes of separation
when recycling.
GB
5