Setting Media; Using A Floppy Disk - Sony UPA-PC100 Mode D'emploi

Setting Media

1
With its label facing up, insert the PC card
completely into its slot.
Note
Push the PC card in completely. If the PC card is
not inserted completely, you may not be able to
read image data stored on the card.
2
Touch the [OK] button in the lower right corner of
the screen.
3
When the message prompts you to remove the PC
card, push in the eject button 1 , and then pull the
PC card straight out 2.
Note
To prevent losing valuable data or damaging the
PC card, never remove the PC card from the slot
until the message prompts you to remove it.
4
Touch the [OK] button in the lower right corner of
the screen.
14
Label
Eject button
1
2

Using a Floppy Disk

Insert a floppy disk when the screen below is
displayed.
1
Insert the floppy disk completely into the floppy
disk drive.
2
Touch the [OK] button in the lower right corner of
the screen.
3
When the message prompts you to remove the
media, press the eject button 1, and then pull the
floppy disk from the drive 2.
Eject button
1
2