Hot Splash HS25 Mode D'emploi page 10

STEP3 (Start)
Push the ON/OFF button(1) to start the heat pump. The current water
temperature will appear and the heat pump will start automatically. The
operating LED(8) indicates the heat pump is active. The fan LED(7) indicates
the fan is running.
The heat pump won't operate when it's too cold outside. TCO will blink on
the display. Please check the information about the alarms in section 9.2.
The heat pump won't start when the desired water temperature is reached
(define set point in step 6). Meanwhile the current water temperature is
shown on the display. The heat pump will start automatically when the water
temperature drops 1°C below set point.
The heat pump is equiped with a 2min30sec built-in compressor delay to
protect control circuit components. Each time the compressor is switched
on the timer starts to count. Operating LED(8) is blinking, indicating the heat
pump isn't using the compressor at current moment. Operating LED(8) is
active, indicating the heat pump is using the compressor at current moment.
STEP4 (Start)
Verify after a few minutes that the air exhausted by the heat pump is getting
cooler
STEP5 (running)
Allow the heat pump and filter/water pump to initially run 24 hours a day until
the desired water temperature is reached.
Several days will be needed to bring the temperature of the swimming
pool water to its desired water temperature, depending the initial water
temperature, ambient temperature and pool volume.
A good pool cover and insulation of the piping to and from the swimming
pool can reduce the warming up time considerably.
10
English