Olympus S-DVD-100 Manuel D'utilisateur page 36

PC mode (available only when a PC is connected)
4
Turn the power switch on.
Check that the power indicator (green) and the PC-side indicator (green) are illuminated.
5
Run OLYMPUS Master from your PC.
For details on software operations, refer to the help and the on-line manual of the OLYMPUS Master
software.
Notes
• While the unit is processing in the PC mode, do not change the setting of the Dock&Done/PC mode switch or
disconnect the USB cable or AC adaptor. This may cause data loss while recording from your PC to the unit, or a
system error on the PC rendering it inoperable. In this case, shut down your PC, power off the unit, and restart your
PC and then the unit.
• Be sure to install B's CLiP6 software before you use OLYMPUS Master software.
• When writing data to a disk using a PC, writing may sometimes fail. Be sure to confirm that the writing was
successful each time.
Tip
When you use DVD+RW or DVD-RW disks, set "Safety mode" of B's CLiP6 software to on to increase those
reliability (but writing speed will be slower). The default setting of safety mode is on when installing. For details,
refer to the B's CLiP6's help.
EN-36
I O