Installation Instructions; Prepare Dishwasher; Install Dishwasher; Make Electrical Connection - KitchenAid BRIVA KIDS42 Instructions D'installation

Prepare Dishwasher

IMPORTANT: If hot water accessory tank (accessory Part
No. 4396282) will be used, the tank must be installed first.
1. With a utility knife, cut along the back right corner of inner
carton.
cut along
this corner
2. Remove inner carton. Leave dishwasher on bottom pad.
3. Install faucet (not included). The dishwasher is shipped ready
for installation of a one-hole faucet. If a two-, three- or four-
hole faucet is to be installed, the holes must be added by a
qualified plumber according to the faucet manufacturer's
specifications.

Install Dishwasher

1. Mark countertop and apply a 1/4" (6.4 mm) bead of silicone
caulk 1/4" (6.4 mm) away from dishwasher cutout on sides
and 7/16" (1.1 cm) on front and back.
1/4" (6.4 mm)
bead of silicone
caulk
WARNING
Excessive Weight Hazard
Use two or more people to move and install dishwasher.
Failure to do so can result in back or other injury.
2. Set the dishwasher into countertop cutout. Make sure front of
dishwasher is parallel to front edge of countertop.
IMPORTANT: To prevent damage to
right-hand hinge, open dishwasher lid
before setting dishwasher into
countertop cutout.
3. Immediately remove any excess caulking.

INSTALLATION INSTRUCTIONS

back of
inner carton
dishwasher
cutout
4. Install two clamp brackets, evenly spaced, on front, back and
left (sink) side clamp rails. Optional: If space permits, install
two clamp brackets, evenly spaced, on the right side rail.
To install clamps:
Hook upper clamp onto rail. Use flat-blade screwdriver to
attach clamp to rail.
Use 7/16" deep-well socket and securely tighten nut
against lower clamp. Do not overtighten.
rail
countertop

Make Electrical Connection

If you are:
direct wiring, use Option 1
using a power supply cord, use Option 2
Option 1, Direct wired method
If dishwasher must be directly wired to meet local codes, the
power supply cord must be removed and dishwasher wired
directly. Electrical connections must be contained within the
terminal box and meet all national and local codes and
ordinances.
Route direct wire so that it does not touch lower part of
dishwasher tub to prevent undue sound and vibration.
If power supply cord is removed, the dishwasher must be
connected with copper wire only.
WARNING
Electrical Shock Hazard
Disconnect electrical power at the fuse box or circuit
breaker box before installing dishwasher.
Failure to do so can result in death or electrical shock.
1. Disconnect power.
upper clamp
lower clamp
7