KitchenAid BRIVA KIDS42 Instructions D'installation page 4

KIDS42 Product dimensions
SIDE
1-3/4" (4.4 cm)
to center of single
hole faucet
water inlet
valve
5-25/32"
(14.7 cm)
9-7/16"
(24.0 cm)
20-21/32" (52.5 cm)
(between clamp rails)
22" (55.9 cm)
KIDS42 Cabinet requirements
*NOTE: The cutout must be accurately cut to the dimensions shown within
1/16" (1.6 mm). Dishwasher top flange overlaps the countertop cutout
by 7/16" (1.1 cm) on front and back edges and 1/4" (6.4 mm) on sides.
• Cabinetry and countertop must be sturdy enough to support loaded
dishwasher and sink (400 lbs. [181.4 kg]).
21-1/8"
(53.7 cm)
(see *NOTE)
A
It is recommended that sink
water and drain line
connections be located on
this side of cabinet.
4
factory
installed air
gaps
8"
(20.3 cm)
9-9/16"
(24.3 cm)
center of
sink drain
dishwasher
drain
for base cabinet
installations, min. 42"
(106.7 cm) width required
A
40" (101.6 cm)
(see *NOTE)
A
It is recommended
that dishwasher water
and drain line
connections be
located on this side
of cabinet.
FRONT
40-1/2" (102.9 cm)
16-7/8" (42.9 cm)
to center of single
hole faucet
5-1/2 ft. (1.7 m)
3-prong ground-type
power supply cord
39-11/16" (100.8 cm)
(between clamp rails)
7/16" (1.1 cm) min.
flat surface required
IMPORTANT: Corner radius dimensions
specified must be used. If they are not,
the dishwasher will not fit the opening.
B C
25" (63.5 cm) deep
countertop
Countertop must be
level.
1-1/4"
(3.2 cm)
GFCI reset
buttons
14" (35.6 cm)
18-5/16" (46.5 cm)
backsplash
21-1/8"
(53.7 cm)
(see *NOTE)
radius: 2-1/4" (5.7 cm)
A
radius: 1" (2.5 cm) – the
B
right back corner must be
cut to this radius
C
Back right corner: If countertop is
more than 3/4" (1.9 cm) thick,
measure down 3/4" (1.9 cm) and cut
45° bevel all the way around radius.
3/4"
45°
(1.9 cm)
19-3/8"
(49.2 cm)
maximum
opened lid
height
21"
(53.3 cm)
22-1/32"
(56.0 cm)