Step 3: Installing Disk Drives - Promise Technology VTRAK J610s Guide De Démarrage Rapide

Step 3: Installing Disk Drives

Populate the VTrak with 3.5-inch SAS or SATA disk drives.
Install all of the drive carriers into the VTrak enclosure to ensure proper airflow,
even if you do not populate all the carriers with disk drives.
Figure 10.Drive carrier mounting holes
AAMUX
Mounting Holes
1. Remove the front bezel (J310s only).
2. Remove a disk drive carrier.
3. Optional. The AAMUX adapter is recommended for VTraks with two I/O
modules, so that both modules can access a SATA disk drive.
Place the optional AAMUX into the disk drive carrier and attach it with the
four screws.
• Install only the screws supplied with the AAMUX.
• The AAMUX fits into the carrier with the SAS connector at the back. See
See Figure 12.
• Snug each screw. Be careful not to over tighten.
4. Carefully lay the drive into the drive carrier at the front, so that the screw
holes on the bottom line up.
Use only the counter-sink screws supplied with the VTrak. Use of
other types of screws can damage the adjacent drives.
Disk Drive Mounting Holes
with AAMUX
Disk Drive Mounting Holes
without AAMUX
Caution
11
Step 3: Installing Disk Drives