Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Start-up and operation
Before beginning with start-up and operation, make sure that all the cables are
connected correctly.
Switching the subwoofer on/off
You switch the Individual Sound loudspeaker system on in position "I – ON"
with the ON/OFF switch
.
If the subwoofer is connected as described on page 15, there is no need to
switch the subwoofer on and off separately any more. After switching on the
subwoofer for the fi rst time, it is always switched on and off immediately with
the Loewe TV set.
Settings on the Loewe TV set
Make the necessary settings on your Loewe Auro Preceiver as described in the
Auro operating manual in the chapter "Initial start-up".
Phase switch/bass intensity
The "Phase" switch
and the "Bass intensity" knob
bass reproduction.
We recommend you to proceed as follows:
•
If the subwoofer is in the corner of the room, set the bass intensity knob to
"Min".
•
If the subwoofer is against a wall, set the bass intensity knob to the center
position.
•
If the subwoofer is standing freely in the room, set the bass intensity knob to
"Max".
•
Start DVD playback for example and select a title with bass parts.
•
Have a second person activate the phase switch whilst you sit and listen.
•
Decide for yourself which switch position reproduces the best bass sound.
•
Set the bass intensity to suit your taste if necessary.
- 16
Setting the crossover frequency
The "Crossover Frequency" knob
frequency for bass reproduction between 50 Hz and 250 Hz depending on
which speakers you have connected. We recommend setting this to 120 Hz for
the Center Stand.
Cover on the subwoofer
After you have made the settings described in "Start-up and operation", replace
the cover on the rear of the subwoofer.
Turning the TV set
The fully assembled unit of TV set and TV stand can be turned 45° to either side
by hand.
enable you to optimize
gives you the possibility of setting the limit
Publicité
Chapitres
Table des Matières
