Parts Description - Princess 01.341500.01.001 Mode D'emploi

Instruction manual
• The appliance shall, under no
circumstances, be covered with insulating
material or similar material.
• The heater must not be located immediately
below a socket-outlet.
• Do not use this heater if it has been dropped.
• Do not use if there are visible signs of
damage to the heater.
• Use this heater on a horizontal and stable
surface, or fix it to the wall, as applicable.
• WARNING: Do not use this heater in small
rooms when they are occupied by persons
not capable of leaving the room on their own,
unless constant supervision is provided.
• WARNING: To reduce the risk of fire, keep
textiles, curtain, or any other flammable
material a minimum distance of 1m from the
air outlet.
• The heater needs to be installed so that the
switches and other controls cannot be
touched by a person in the bath or shower.
4

PARTS DESCRIPTION

1. On / Off switch
2. Display
3. Touch button control panel
4. Heater
5. Feet
6. Wall bracket
INSTALLATION
Foot assembly
• Before using the heater, the feet must be fitted to the unit. (image
1)
• These are to be attached to the base of the heater using the 8
ST12x4mm screws provided. (image 2)
• Take care to ensure that the feet are located correctly on the
bottom end of the heater.
• The heater should stand vertically once the feet are installed
(image 3). If the heater tilts backwards then please remove the
feet and rotate them before fitting again. (image 4)