Functions - Astralpool Control Basic Manuel D'installation

Functions

:
CALIBRATION
Press
•
Sequence Standard calibration buffer solution 7 and 4 pH or Redox 465mV
•
SET POINT
Press:
•
hold down
•
•
•
Press
•
PROGRAM
Press to set the following Item:
•
•
•
SETPOINT 7.4ph or 750mV
• Select with the button
• It's possible to adjust from 0 to 14 pH value and 0 to 1000 mV for Redox.
SETPOINT TYPE ACID
• Select with the button
• It's possible to adjust Acid or Alkaline dosing and High or Low for Redox
Code 0000137847
INSTRUCTION SETTING
for 3 Seconds
and change the value with key
7.4ph
750mV
(together) for 5 Seconds and run Program Setup
Configuration Pump
§
select pH or Redox
Language
§
With the button
Flow
§
Select with the button
§
It's possible to enable(ON) or disable (OFF) signal input flow (high voltage)
connected in parallel to the recirculation pump.
and set with
and set with
It's possible to have 5 language EN, IT, ES, DE, FR
Rev 1.0 2