Maintenance And Inspection - Hitachi Koki SV 12SG Instructions De Sécurité Et Mode D'emploi

English

MAINTENANCE AND INSPECTION

WARNING:
1. Emptying and cleaning the dust bag
If the dust bag contains too much saw dust, dust collection will be affected. Empty the
dust bag when it gets full.
Remove the dust bag, open the fastener, and dispose of the contents.
2. Inspecting the sanding paper
Since use of worn-out sanding paper will degrade efficiency and cause possible damage
to the pad, replace the sanding paper as soon as excessive abrasion is noted.
3. Inspecting the screws
Regularly inspect all screws and ensure that they are fully tightened. Should any of the
screws be loosened, retighten them immediately.
WARNING:
4. Inspecting the carbon brushes
For your continued safety and electrical shock protection, carbon brush inspection and
replacement on this tool should ONLY be performed by a HITACHI AUTHORIZED
SERVICE CENTER.
5. Service and repairs
All quality power tools will eventually require servicing or replacement of parts because
of wear from normal use. To assure that only authorized replacement parts will be
used, all service and repairs must be performed by a HITACHI AUTHORIZED SERVICE
CENTER, ONLY.
6. Service parts list
CAUTION: Repair, modification and inspection of Hitachi Power Tools must be carried
out by an Hitachi Authorized Service Center.
This Parts List will be helpful if presented with the tool to the Hitachi Authorized Service
Center when requesting repair or other maintenance. In the operation and maintenance
of power tools, the safety regulations and standards prescribed in each country must
be observed.
16
Be sure to switch power OFF and disconnect the plug from the
receptacle during maintenance and inspection.
Using this orbital sander with loosened screws is extremely dangerous.