Functional Description - Milwaukee M12 2334 Série Manuel De L'utilisateur

funcTional descripTion

5
4
2
3
1. Power button
High: Red LED
Medium: White LED
Low: Blue LED
assembly
Warning
charger specified for the battery. For specific
charging instructions, read the operator's man-
ual supplied with your charger and battery.
Inserting/Removing the Battery
To insert the battery, slide the pack into the body
of the battery holder. Make sure it latches securely
into place.
Insert the power cable (from inside the battery
holder pocket) into the power cable port on the
battery holder.
Place the battery holder into the pocket and zip
closed. If necessary, unzip the expansion zipper
to accommodate larger battery packs.
To remove the battery, push in the release buttons
and pull the battery pack away from the holder.
operaTion
The power button is located on the upper left side
of the jacket. The button is on the outside of the
jacket on Cat. No. 2334, and on the inside on Cat.
No. 2337 and 2346.
To turn on, press and hold the heated jacket power
button (1 to 2 seconds). The jacket will be turned
to High and the red LED will light.
Temperature setting can be adjusted at any time
by pressing the heated jacket power button. Each
press will cycle through the heated jacket's tem-
perature settings.
To turn off the heated jacket, press and hold the
heated jacket power button until the LED turns off
(1 to 2 seconds).
If the heated jacket turns off unexpectedly, check
connections and charge the battery pack.
1
M12
2. Battery holder
3. Power cable port
4. Battery holder pocket
5. Power cable
Recharge only with the
Warning
a l w a y s u n p l u g t h e c h a r g e r a n d
remove the battery pack and battery holder
from the heated jacket before performing any
maintenance. Never disassemble the heated
jacket, battery pack or charger. Contact a
milWaukee service facility for ALL repairs.
If the heated jacket does not start or operate
properly with a fully charged battery pack, clean
the contacts on the battery pack. If the heated
jacket still does not work properly, return the heated
jacket, charger and battery pack, to a MILWAUKEE
service facility for repairs.
Warning
injury and damage, disconnect and
remove battery pack and battery holder from
battery holder pocket before washing. Never
immerse your battery holder, battery pack,
or charger in liquid or allow a liquid to flow
inside them.
To clean the heated jacket:
1. Remove battery pack and battery holder.
2. Hand wash heated jacket in cold water. Do not
use bleach. Do not wring. Do not machine wash
even though machine may include a hand wash
or equivalent cycle.
3. Hang dry. Do not machine dry. Do not iron.
accessories
Warning
pack before changing or removing
accessories. Only use accessories specifi-
cally recommended for this tool. Others may
be hazardous.
For a complete listing of accessories refer to your
MILWAUKEE Electric Tool catalog or go online
to www.milwaukeetool.com. To obtain a catalog,
contact your local distributor or service center.
3
care
To reduce the risk of injury,
To reduce the risk of personal
Always remove battery