Publicité
Les langues disponibles
Les langues disponibles
User Manual
IR Control
The included IR receiver and emitter cables can be used to control either a
source device from a remote location, or a display device from the source
location. For this feature, take care to position the IR Receiver in clear view
of an IR remote control and connected to the 3.5mm IR RX port on either unit,
finally connect the emitter cable to the IR TX port on the alternate unit and
position it in a clear line of sight to the IR receiver on a desired device to
control.
Serial Control
For serial control, take care to connect a serial device to the Serial port on the receiver and connect the
serial port on the transmitter to a serial or USB port on the source device using an RS-232 cable or RS-
232 to USB cable.
Troubleshooting
If there is no video on the display, follow the steps below:
•
Check that all devices are receiving power. Ensure that the DC plug and jack are firmly connected and
that the power LED on both the transmitter and receiver are illuminated.
•
Check the AV connections between all devices are firmly secure in their respective ports.
•
Check that the LINK led is illuminated. If not, please disconnect and re-connect the fibre optic
connectors.
•
With HDMI it may be helpful to unplug and re-connect their HDMI connections to re-initiate the HDMI
handshake.
•
Check the length of the HDMI cables used. For optimal performance, Lindy recommends using high
quality Input & Output HDMI cables up to 2m.
•
Power off all devices, power each device on in the following order: transmitter, receiver, display and
finally the source device.
English
Publicité
