Maintenance; Ipx4 - SoFlow SO1 Mode D'emploi Original

Correct handling of the battery
Never remove the battery from the scooter. Charge the battery for at least 1 hour every 2 months (even when not in use). Never heat the battery or expose it to open fire. Never dispose of the
battery cells together with general waste. Never bring battery contacts into contact with moisture. The ideal operating temperature of the battery is between 10°C and 30°C. Above as well as
below this temperature, the power output deteriorates, resulting in a reduced range and power output.
The life and performance of a battery depends on its age, care and how often it has been used. Compared to other battery models, lithium ion batteries have very low self-discharge and a very
low memory effect, but they need to be charged periodically. Even if you do not use your scooter, the battery must be charged for at least 1 hour every 2 months, otherwise it will lose capacity.
Regular charging will prevent the battery from total discharge. Please note that an excessively discharged battery is irreparably damaged and must be replaced for a fee, hence the battery should
never be completely discharged during operation.
WARNING!

3.5 Maintenance

Do not try to charge the SO1 when the battery is already full. This could diminish the battery's capacity in the long run.
Before every ride, check all screws of the device, especially those of the handle and frontbar, the mudguard and the front and rear wheel. Tighten all screws firmly to ensure safety when using
your SO1.
Before each journey, check that the wheels are undamaged.
Check regularly that the brakes are correctly adjusted. You can adjust the braking force by adjusting the brake cable. If in doubt, contact your dealer.
Thoroughly clean the SO1 with a dry cloth after usage. The front and rear ball bearings must be lubricated from time to time. Ordinary bicycle oil can be used. Oil the area where the axle runs into
the wheel to ensure better durability.

3.6 IPX4

The SO1 is splash-proof according to IPX4 but not waterproof. You may therefore use the SO1 in light rain and drive through puddles on the ground. You must not immerse the SO1 in water or
expose it to heavy rain, otherwise the electronics may be damaged. Further information about the scope of protection according to IPX4 can be found on the Internet.
Definition IPX4
IP First digit for protection against solid particles
X Not specified
copyright by www.soflow.com
IP Digit 2 for protection againts liquids
4 Protected against splashing water from all directions
12