Haier HLTD600AEW Manuel D'utilisation page 20

A1. Attach the power cord ground wire (green) to the cabinet with the green ground
screw. Tighten the screw securely.
A2. Attach the power cord neutral wire (white) and the neutral ground jumper wire
(white) with the center terminal block screw. Tighten the screw securely.
A3. Attach the remaining 2 power cord line wires (red and black) with the outer
terminal block screws. Attach one wire to each terminal block as shown. Tighten
both screws securely.
IMPORTANT: Do not make a sharp bend or crimp the wires at connections.
PART B - 3-WIRE POWER CORD
a
Terminal Block Screw
b
Ground Screw (Green)
c
Neutral-Ground Jumper Wire
(White)
B1. Attach the power cord neutral wire (white) to the center terminal block screw.
Tighten the screw securely.
B2. Attach the remaining 2 power cord line wires (red and black) with the outer
terminal block screws. Attach one wire to each terminal block as shown. Tighten
both screws securely.
B3. Attach the neutral ground jumper wire (white) to the cabinet with the green
ground screw. Tighten the screw securely.
IMPORTANT: Do not make a sharp bend or crimp the wires at connections.
18
a
b
c
d
e
f
d
Power Cord Line Wires (One Red;
One Black)
e
Power Cord Neutral Wire (White)
f
Power Cord