Securing Your Child In The Vehicle; Care And Maintenance - Graco 8H98 Notice D'utilisation

3
Secure the vehicle's diagonal belt with the lock-off latch
I. Release the lock-off latch.
II. Place the seat belt through the lock-off latch and pull it tight.
III. Lockup the lock-off latch.
4
Recheck if the car seat is securely fitted after completing the above opera-
tion. (Check by moving the car seat back and forth)
Make sure that both the lap belt and diagonal belt are not twisted or fold-
ed, and will not prevent the vehicle seat belt to be fully and rightly func-
tioned.
DO NOT insert the top bar in forward facing mode
Securing your Child in the Vehicle
DO NOT remove the protective shoulder straps, which is designed to pre-
vent your child from slipping.
1
Press the red button to release the harness buckle
2 Loosen the harness by pressing the harness adjuster and adjust the shoul-
der harness to suitable length
3 Attach both shoulder straps together then insert it into the harness buckle
(Fig. 30).
4
Pull the harness adjuster webbing to adjust the shoulder strips to
suitable length that allow your child tightly secured at the car seat
(Fig. 31) – Pull.
Care and Maintenance
1 The seat pad is removable. Use cold water for hand washing and refer to
the washing label attached on the car seat for correct method. DO NOT
clean by machine wash or dry cleaning.
2 Remove the foam in the inner cushions before washing.
3
The child restraint must not be used without the cover. The seat cover
should not be replaced with any other than the one recommended by the
manufacturer because the cover constitutes an integral part of the restraint
performance.
(Fig.
(Fig. 29) – Press.
(Fig. 26).
(Fig. 27).
28).
19
GB GB