Panasonic AVC Intra AJ-YBX200G Mode D'emploi page 9

Installation into the AJ-HPS1500
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire
or electric shock, do not perform any servicing other than as directed in the operating instructions
unless you are qualified to do so.
1
Unscrew the two screws from the AJ-
YBX200G to remove the bracket.
Bracket
2
Unscrew the two screws from the AJ-
YBX200G to remove heat sink 1.
Heat
sink 1
3
Unscrew the three screws and nuts from
the AJ-YBX200G to remove heat sink 2.
Heat sink 2
Screws
4
Remove the cooling sheets if they remain on
the AJ-YBX200G after removing heat sinks 1
and 2.
Screws
(black)
5
Make sure that the power of the AJ-
HPS1500 is turned off.
Cooling sheet
Screws
(black)
Cooling
sheet
E-8