Panasonic AVC Intra AJ-YBX200G Mode D'emploi page 5

6
Place the AJ-YBX200G into the terminal of
5
the board in Step
four 2.6 mm screws.
2.6 mm
screws
7
Reconnect the cable removed in Step
was originally.
8
Reinsert the No.5 board into its original
position. In this operation, allow the cable
connected in Step
the No.5 board. (See Figure
flexible cables removed in Step
original positions.
9
Return the side panel to the original position
and secure it with the screws. In this
operation, ensure that the cable
disconnected in Step
slot.
If the flexible cables are not locked or the board
is inserted at a slant, the camera recorder may
have trouble recording.
and fix it by using the
5
as it
7
to run along the slot of
5
) Insert the
4
into the
5
is not caught in the
E-4