Changing Modes - Storch 559000 Mode D'emploi

Changing modes

Creeper /Dolly mode to workbench mode
Put the Creeper / Dolly on its back and pull back on the
spring loaded locking pins from one leg and pull the leg
upward.
Two holes are provided on one end of the product for
attaching a traction rope connector when moving heavier
objects.
Exercise caution when moving heavy objects.
Creeper mode
Use this mode to perform jobs in low spaces. Also put the
product into this mode when storing or moving it. A car-
rying handle is provided.
CAUTION:
Do not step or stand on the work surface in Creeper mode.
Dolly mode
Place objects in the center of the platform surface. Exerci-
se caution when moving tall objects to prevent them from
sliding or falling over.
.
CAUTION:
Do not step or stand on the work platform surface in Dolly
mode.
NOTE:
You must pull out the spring loaded locking pins when
opening the legs. Otherwise they will not open.
2. Pull each leg up and out and push hinged bracket until
it locks in place.
3. Press the spring button on each leg and pull each leg
out until the spring button clicks again.
19 Original instruction