Makita BFH040 Manuel D'instruction page 5

(Note: The battery cartridge can be inserted even
while the interlock switch is lowered. Once the
battery cartridge is inserted, the interlock switch will
rise automatically.)
• Do not use force when inserting the battery
cartridge. If the cartridge does not slide in easily, it
is not being inserted correctly.
Switch action
1
CAUTION:
• Before inserting the battery cartridge into the tool,
always check to see that the switch trigger actuates
properly and returns to the "OFF" position when
released.
To start the tool, simply pull the switch trigger. Release
the switch trigger to stop.
Automatic power off
When the switch trigger is kept being pulled for three
minutes without driving screws or tightening bolts, the
tool automatically stops. To restart the tool, release the
switch trigger and then pull it again.
Reversing switch action
A
1
CAUTION:
• Always check the direction of rotation before
operation.
• Use the reversing switch only after the tool comes
to a complete stop. Changing the direction of
rotation before the tool stops may damage the tool.
• When not operating the tool, always set the
reversing switch lever to the neutral position.
This tool has a reversing switch to change the direction of
rotation. Depress the reversing switch lever from the A
004041
1. Switch trigger
004042
1. Reversing
switch lever
B
side for clockwise rotation or from the B side for counter-
clockwise rotation.
When the reversing switch lever is in the neutral position,
the switch trigger cannot be pulled.
Lighting up the front lamp
For models BFH040F/BFH090F/BFH120F only
1
CAUTION:
• Do not look in the light or see the source of light
directly.
Pull the switch trigger to light up the lamp. The lamp
keeps on lighting while the switch trigger is being pulled.
The light automatically goes out 10 seconds after the
switch trigger is released.
NOTE:
• Use a dry cloth to wipe the dirt off the lens of lamp.
Be careful not to scratch the lens of lamp, or it may
lower the illumination.
LED indicator
LED indicator on the tool shows the following functions.
Beeper
For models BFH040F/BFH090F/BFH120F only
Also, Beeper on the tool shows the following functions.
5
004043
1. Front lamp
004044
1. LED indicator
1