Dimensions - Nordelettronica NE100 Instructions D'emploi

CONTROL PANEL NE101
CONTROLS:
- (1) Push button with warning light (7) to turn internal lights on and off.
- (2) Push button with warning light (8) to turn external light on and off.
(The external light goes off automatically with the engine running. The internal light switch also
acts as a master switch for the external light).
- (3) Push button with warning light (9) to turn the pump on and off.
TEST:
- (6) Push button to carry out the test for tank level and battery voltage.
Push once to activate the following for 20 sec. :
Push a second time to activate the following for a further 20 sec. :
DISPLAY:
- (4)Voltmeter with led to show the state of recharge for the car and service battery.
Battery voltage (Volt)
When power is on the leds illuminate in sequence (until the one corresponding to the
battery value is reached) to signal that the service battery (B2) is being charged.
- (5) Voltmeter with led to show the level of drinking water tank
- (12) Led on when the recycle tank is full.
- (13) Led on when power is on.
- (10) Led showing that the Voltmeter (4) is dedicated to reading the service battery (B2)
- (11) Led showing that the Voltmeter (4) is dedicated to reading the car battery (B1)
- (7) Led on when the internal light relay on the NE100 distribution panel is enabled.
- (8) Led on when the external light relay on the NE100 distribution panel is enabled.
- (9) Led on when the pump relay on the NE100 distribution panel is enabled.
MANAGEMENT OF FLAT SERVICE BATTERY
If the service battery (B2) voltage drops below 10V the red led on the battery voltmeter starts to flash and after
approximately one minute the NE100 distribution panel disables the various power supplies to the lights and
pump. To reactivate the relays press the corresponding key. However, if the battery remains below 10V they
will deactivate again after one minute.

DIMENSIONS

: (L x H) 250 x 78 mm
- service battery (B2) reading
- drinking water tank level reading
- car battery (B1) reading
- drinking water tank level reading
< 10
10÷11
11÷12
12÷12,6
>12,6
Display
Flashing red led
Red led on
Green led 1/3 on
Green led 2/3 on
Green led 3/3 on
:
Fig. 1