Doors - KitchenAid KFFS20EYMS Guide D'utilisation

PROBLEM
Water is leaking or dripping
from the dispenser system
NOTE: A few drops of water
after dispensing is normal.
Water continues to drip
from the dispenser beyond
the first few drops.
Water is leaking from the
back of the refrigerator
Water from the dispenser is
warm
NOTE: Water from the
dispenser is only chilled to
50°F (10°C).
PROBLEM
The door(s) or drawer will
not close completely
The doors are difficult to
open
The doors appear to be
uneven
The doors do not open or
close as expected
POSSIBLE CAUSES
The glass was not held under the
dispenser long enough
The refrigerator has just been installed
The water filter was recently changed
The water line connections were not
fully tightened
Recently removed the doors and did
not fully tighten water line connection
The refrigerator has just been installed
A large amount of water was recently
dispensed
Water has not been recently dispensed The first glass of water may not be cool. Discard the first
The refrigerator is not connected to a
cold water pipe
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
POSSIBLE CAUSES
The door or drawer is blocked open
A bin or shelf is in the way
Recently installed
The door gaskets are dirty or sticky
The doors need to be aligned or the
refrigerator needs to be leveled
The refrigerator tilt needs to be
adjusted
SOLUTIONS
Hold the glass under the dispenser 2 to 3 seconds after
releasing the dispenser lever.
Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See "Water Dispenser."
Flushing the water system removes the air from the lines
which causes the water dispenser to drip. Flush the water
system. See "Water Dispenser."
See "Connect the Water Supply."
See "Remove and Replace Refrigerator Doors and Drawer
Front."
Allow 24 hours after installation for the water supply to cool
completely.
Allow 3 hours for the water supply to cool completely.
glass of water dispensed.
Make sure the refrigerator is connected to a cold water pipe.
See "Water Supply Requirements."

Doors

SOLUTIONS
Move food packages away from door(s). Remove ice or other
items which have fallen onto the floor of the freezer
compartment.
Push bin or shelf back into the correct position.
Remove all packaging materials.
Clean gaskets and contact surfaces with mild soap and warm
water. Rinse and dry with soft cloth.
See "Door Closing and Door Alignment."
Adjust the refrigerator tilt. See "Door Closing and Door
Alignment."
21