Window Slider Kit Installation - Qlima P926 Manuel D'utilisation

Table des Matières

Les langues disponibles

Fig. 1

Fig. 2

Fig. 3

Fig. 4

Fig. 5

INSTALLATION

• The unit should be placed on a firm foundation to minimize noise and vibration.

For safe and secure positioning. place the unit on a smooth, level floor strong

enough to support the unit.

• The unit has casters to aid placement, but it should only be rolled on smooth,

flat surfaces. Use caution when rolling on carpeted surfaces. Use caution and

Protect floors when rolling over wood floors. Do not attempt to roll the unit

over objects.

• The unit must be placed within reach of a properly rated grounded socket.

• Never place any obstacles around the air inlet or outlet of the unit.

• Allow at least 30cm of space away from the wall for efficient air conditioning.

• The hose can be extended, but it is the best to keep the length to minimum

required. Also make sure that the hose does not have any sharp bends or sags.

INSTALLATION INSTRUCTIONS

EXHAUSTING HOT AIR

In the Cool Mode the appliance must be placed close to a window or opening

so that the warm exhaust air can be ducted outside.

First position unit on a flat floor and make sure there's a minimum of 12"

(30cm) clearance around the unit, and is within the vicinity of a single circuit

outlet power source.

Extend either side of the hose {Fig.1 )and screw the hose inlet (Fig.2).

Extend the other side of the hose and screw it to the hose outlet (Fig.3).

Install the hose inlet into the unit .

Affix the hose outlet into the window slider kit and seal. (Fig.4 & 5).

Your window slider kit has been designed to fit most standard vertical

and horizontal window applications, however, it may be necessary for you

to modify some aspects of the installation procedures for certain types of

windows. The window slider kit can be fastened with screws.

If the window opening is less than the minimum length of the window

slider kit, cut the end without the hold in it short enough to fit in the

window opening. Never cut out the hole in window slider kit.