Makita AN923 Manuel D'instruction page 9

► 1. Trigger lock 2. Change lever
When the tool is not to be used for an extended period
of time, lubricate the tool using pneumatic tool oil and
store the tool in a safe place. Avoid exposure to a direct
sunlight and/or humid or hot environment.
1
2
Maintenance of the compressor, air
set and air hose
1
► 1. Drain cock
1
► 1. Air filter
After operation, always drain the compressor tank and
the air filter. If moisture is allowed to enter the tool,
It may result in poor performance and possible tool
failure.
Check regularly to see if there is sufficient pneumatic
oil in the oiler of the air set. Failure to maintain sufficient
lubrication will cause O-rings to wear quickly.
► 1. Oiler 2. Pneumatic oil
Keep the air hose away from heat (over 60°C, over
140°F), away from chemicals (thinner, strong acids or
alkalis). Also, route the hose away from obstacles which
it may become dangerously caught on during operation.
Hoses must also be directed away from sharp edges and
areas which may lead to damage or abrasion to the hose.
9 ENGLISH
1
2