B.A. International ULTRASONIC CLEANING UNIT Mode D'emploi page 8

5. Clean away saw dust. Position the mounting rim over the cut out and check fit.
Adjust hole if required.
6. Remove rim. Carefully apply a bead of clear silicone (GE 732 or equivalent)/
waterproof clear silicone sealant ½ inch wide, ⅛ inch high around the cut out.
Bead of silicone
7. Position mounting rim over cut out. Screw rim to countertop with (4) #6 x ¾
inch stainless steel Type A screws.
8. Carefully apply a bead of silicone ⅜ inch wide, ⅛ inch high around the inside
edge of the mounting rim.
9. Set the tank into the rim. Allow the silicone to squeeze out. Wipe the excess
silicone.
10. Allow the tank to set for at least eight hours without being disturbed.
11. After the silicone has cured, carefully scrape any excess silicone, being
careful not to scratch the rim or countertop.
Connecting the Drain
Protruding through the bottom of the tank assembly on a recessed machine is a
drain valve and associated fittings and a 36" length of tygon tubing.
Every recessed installation is unique because of different counter sizes, access to
waste lines, etc., and should be done by a plumber or technician in accordance
with local plumbing codes.
If a sink and sink drain are near the location the recessed cleaner is to be
installed, we recommend changing the sink's tailpiece/sink's waste system to a
"dishwasher tailpiece"/ dishwasher waste system. Then, using an appropriate
combination of adapters/fittings, the tygon tubing can be connected to the
tailpiece/waste. See sketch.
-About 1/2"
8
(Not to scale)
Mounting rim