B.A. International ULTRASONIC CLEANING UNIT Mode D'emploi page 10

STEP
1
2
3
4
5
NOTE: If this is the first time you are running the cleaner or you have changed
the cleaning solution, you must degas the solution. Fresh solutions contain many
dissolved gasses which reduce effective ultrasonic action. Although solutions will
naturally degas over time, operating the machine for five to ten minutes before
using it to clean will accelerate the degas process.
Start Up
Select the appropriate Cleaning Solution.
Dilute with warm tap water as specified and fill one
half to two-thirds of the tank.
Add parts to be cleaned. Use a basket or other
accessory which keeps material off the bottom of
the tank. If necessary, add more solution to bring
the level to about 1 inch from the top of the tank.
Plug the cleaner's line cord into a grounded/earthed
outlet.
To activate your machine, simply set your timer to
the number of minutes desired for cleaning. These
self-timing units will automatically shut themselves
off at the end of the cycle.
For recessed installations with an optional remote
timer... connect the machine's power cord to the
outlet on the rear of the remote timer and connect
the remote timer's power cord to a grounded/
earthed outlet. Set the machine's timer to the
"HOLD" position. Then set the timer on the remote
to the number of minutes desired for cleaning.
10
ACTION