Unpack, Set-Up And Start-Up - B.A. International ULTRASONIC CLEANING UNIT Mode D'emploi

Unpack, Set-Up and Start-Up

Unpack

Remove your ultrasonic cleaner from its shipping container and inspect it for
any possible damage which may have occurred during shipping. (Claims for
shipping damage should be made immediately against the carrier.)

Check the serial number of your machine with the serial number on the
shipping carton. If they are not the same, contact your dealer.
Set-Up
Table Top Machines

Select your desired location for the cleaner. It should be in close proximity to
a sink or waste lines to facilitate ease of draining. A drain assembly,
supplied with the cleaners having drains, will allow you to place the unit on
either side of the sink or to connect it directly into a waste line. Provide at
least two inches all around the machine to allow for adequate cooling.
Attaching the Drain Assembly for units with 3/8 inch drain

Open bag and remove pre-assembled drain fitting.

Loosen nut on elbow. Refer to the sketch.

Position machine so that you are facing the Stainless Steel drain tube.

Slide assembly over drain tube.

Adjust position of drain fitting as desired. (Drain right or left)

Hand-tighten. Nut should be against the rear
panel. Do not over tighten. If further
tightening is needed, an adjustable or 13/16"
open-ended wrench is recommended.

Feed end of drain through pinch clamp.

Secure plastic tubing into clip at top of machine.
Hose
Clip
Drain
Nut
6
Hose
Pinch clamp