Changing The Hose Length; Maintenance - TOOLCRAFT TC-AHR 9 Notice D'emploi

c) Changing the hose length
Always disconnect the product from the compressed air supply before carrying out any
maintenance or repair work.
• You can change the length of the hose using the hose stop ring.
• Carefully loosen the two screws on the hose stop ring (4) using a suitable screwdriver. Pull the hose out of the roll
and slide the hose stop ring to the desired pull-out length.
• Tighten both screws again. The hose can only be rolled back as far as the hose stop.

11. Maintenance

• The product is low-maintenance and only contains a few parts that require maintenance. Repair work must be done
by a specialist technician.
• The spring force of the hose reel may drop over time. If this occurs, contact a technician to adjust the spring force.
This requires the left half of the hose reel housing to be removed and the spring mechanism to be rotated in a
clockwise direction.
• Keep the hose clean to ensure that the product works properly.
• Remove any dirt that accumulates on the connecting parts. Regularly check the valves to ensure that there are no
loose connections, leaks, cracks or other signs of damage.
• Check the mounting components from time to time to ensure that there are no loose connections or signs of
damage.
19