Operating Elements; Preparation For Mounting - TOOLCRAFT TC-AHR 9 Notice D'emploi

• Ensure that the product is located near to a suitable source of compressed air.
• Health and injury risks can be minimized by observing the safety information in these instructions. The
product must be properly serviced and maintained. If possible, the product should always be used by
trained personnel. Always follow these operating instructions when using the product.

7. Operating elements

4
3
1 Mounting bracket
4 Hose stop ring

8. Preparation for mounting

Pay attention to the "Safety instructions" section.
Follow the instructions below to determine a suitable location to mount the hose reel:
• The compressed air hose reel must not be installed in areas containing explosive substances, e.g. in storage rooms
containing solvents.
• Mount the product near to a compressed air device approximately 1 m above the ground. The compressed air
feeder hose (2) must be connected to the compressed air source.
• The mounting surface must be able to bear the load of the product.
16
5 6
2
2 Compressed air feeder hose
5 Hose drum
1
3 Compressed air outlet hose
6 Mounting bolts (top/bottom)