Bushnell NatureView HD CAN Mode D'emploi page 13

USING THE SETUP MENU TO
CHANGE SETTINGS
The main purpose of the SETUP mode is to allow you to change the
settings of the camera's parameters (20 different ones are available!) so your
NatureView HD Cam operates exactly the way you want it to. You will do
this by entering the SETUP Menu and pressing the keys below the LCD
display, which will show you each parameter and its setting.
Changing Parameter Settings in SETUP Mode
A wide range of options or "parameters" are
Press MENU
provided to allow you to set the NatureView HD
Cam to your operational preferences. To change
the setting of any parameter you must first switch
to the SETUP mode. Once in SETUP mode,
pressing the MENU button will allow you to
Press DOWN
select any parameter and change its setting. The
name of the parameter and its current setting will
be shown on the LCD. Pressing the RIGHT or
LEFT key scrolls to the next or previous parameter
(RIGHT key to move on to the next parameter and
Press OK
LEFT key to go back to the previous parameter),
and pressing the UP or DOWN key lets you select a different setting for
the currently displayed parameter. Once you have selected your preferred
new setting for a parameter, press the OK button to save the new setting
(actually change it). When you are finished changing the settings of one or
more parameters, press MENU again to exit the SETUP menu. MENU can
also be pressed anytime you want to cancel changing a parameter's setting
after a new setting has been selected (but OK has not been pressed yet).
After setting the parameters to your preferences, be sure to move the switch
to ON to begin actually taking photos or videos. No images will be captured
if the switch is left in the SETUP position (unless you press the RIGHT/Shot
key after exiting the menu)-in fact, the camera will power off automatically after
a few seconds with no key pressed.
13