Argo AR 245C Notice D'installation page 13

Sweep function
The flap starts moving up and down to deliver air
over the sweep range.
HOW TO DISCHARGE THE CONDENSATE WATER
The Humidity removed by the unit is collected and
discharged automatically, but in special conditions some
condensate water could remain inside the unit.
If you are not going to make use of the air conditioner for
a long period, it is necessary to discharge the eventual
condensate water through the service tube for condensate
discharge placed under the bottom of the unit.
IMPORTANT
At the end of the operation close the tube with its stopper.
• The flap automatically closes when the unit
NOTES
is off.
• During the heating operation the flap position
changes according to the settings specified
with the remote control.
CAUTION
• Use the FLAP button on the remote control to adjust
the position of the flap. If you move the flap by hand,
the factual flap position and the flap position on the
remote control may no longer match. If this should
happen, shut off the unit, wait for the flap to close,
and then turn on the unit again; the flap position will
now be normal again.
WARNING
Always switch off the air conditioner before unplugging
G
it from the power socket.
Always unplug the air conditioner before discharging the
G
condensate water collected inside.
13
EG