Allowed / Not Allowed Fuels; Lighting - LA NORDICA INSERTO CRYSTAL 50 Instructions Pour L'installation, L'utilisation Et L'entretien

Picture 19

10. ALLOWED / NOT ALLOWED FUELS

Allowed fuels are logs. Use exclusively dry logs (max. content of water 20%). Maximum 2 or 3 logs should be loaded.
The pieces of wood should have a length of ca. 20-30 cm and a maximum circumference of 30-35 cm.
The not worked-out compressed logs must be used with care to avoid overheating that may damage the
appliance, since these have a high calorific value.
The wood used as fuel must have a humidity content lower than the 20% and must be stored in a dry place. Humid
wood tends to burn less easily, since it is necessary a greater quantity of energy to let the existing water evaporate.
Moreover, humid content involves the disadvantage that, when temperature decreases, the water condensates earlier
in the hearth and therefore in the stack causing a remarkable deposit of soot with following possible risk of fire of the
same.
Fresh wood contains about 60% of H
It is necessary to place this wood in a dry and ventilated place (for example under a roofing) for at least two years
before using it.
Besides others, it is not possible to burn: carbon, cuttings, waste of bark and panels, humid wood or wood
treated with paints, plastic materials; in this case, the warranty on the appliance becomes void.
Paper and cardboard must be used only to light the fire.
The combustion of waste is forbidden and would even damage the appliance and the flue, causing health damages
and claims by the neighborhood owing to the bad smell.
The wood is not a fuel which allows a continuous operation of the appliance, as consequence the heating all over the
night is not possible.
WARNING: The continuous and protracted use of aromatic wood (eucalyptus, myrtle etc.) quickly damages
the cast iron parts (cleavage) of the product.

11. LIGHTING

After the first ignition you can smell bad odors (owing to the drying of the glue used in the garnitures or of the paint)
which disappear after a brief using of the appliance. A good ventilation of the room should always be guaranteed.
To light the fire, it is suggested to use small wood pieces together with paper or other traded lighting means.
It is forbidden to use any liquid substance as for ex. alcohol, gasoline, oil and similar.
You should place a little quantity of fuel and also open the primary air register (left lever completely pulled out, Picture
1 - 1A) and that of secondary air (right lever completely pushed, Picture 1 - 2A)
When wood starts to burn, it is possible to feed it again by opening slowly the door, in order to avoid leaks of smoke,
and close the primary air register (completely pushed) and control the combustion through the secondary air register
according to the provisions of CHAP. 12.
Please always be present during this phase.
Never overload the appliance (see the technical table - max. quantity of fuel that can be loaded / hourly
consumption – (see CHAP. 18). Too much fuel and too much air for combustion can cause overheating and
therefore damage the same.
Never switch on the device when there are combustible gases in the room.
To perform a correct first lighting of the products treated with paints for high temperature, it is necessary to know the
following information:
the construction materials of the involved products are not homogeneous, in fact there are simultaneously parts in
cast iron, steel, refractory material and majolica;
26
R1
C1 C2
Power supply Fan Motor
MORSETTO 6 p5
VDR
L-Ph N
O, therefore it is not suitable to be burnt.
2
INSERTO 50 – 50
C3 C4
MODEL
I 50 I 70
I 60 I 80
I 100
M M
Air Fan-Motor
DANGER
HIGHT VOLTAGE
70 – 80 – 100
VERTICALE –
SA 383
OFF
MIN
MAX
6096801 - Rev.09 – EN