Milky FJ 50 PF Notice D'utilisation page 42

Advanced settings menu
The advanced settings are entered only with a service code. This menu is locked due to
safety reasons and can be adjusted only by a credited service partner.
With pressing mix key, start key and down key at startup, you enter
advanced settings menu.
First you can adjust temperature sensors:
With pressing up key value is increased by 1 unit.
With pressing down key value is decreased by 1 unit.
With pressing right key you switch to another setting.
Water sensor offset adjustments can be made by
increasing or decreasing the current temperature
value. Pay attention on analog value when chan-
ging (seen if key start is pressed).
Milk sensor offset adjustments can be made by
increasing or decreasing the current temperature
value. Pay attention on analog value when chan-
ging (seen if key start is pressed).
Type of device can be chosen:
• P100
• P50
Max DIF milk -water is a temperature difference
between milk and secondary water when device
is in heating phase.
Heater ON add is a temperature difference of
cooling water and setpoint temperature. When
cooling, secondary water will cool down only for
entered temperature value lower than setpoint
temperature of milk.
42