Maintaining The Device; Warranty - visomat comfort 20 Mode D'emploi

F
• Keep the device clean. Check for cleanliness after use. Please
use a soft, dry cloth for cleaning. Do not use benzene, thin-
ners or other strong solvents.
• The cuff may absorb sweat and other fluids. Inspect the cuff
for marks or discolourations after each use. Please use a
synthetic detergent for cleaning and carefully wipe the sur-
face. Do not scrub or machine-wash. Air-dry thoroughly.
• Make sure that liquid cannot get into the air hose.
• Take care when storing the device. Ensure that no heavy
objects are resting on the device or the cuff and that the air
hose is not kinked. Do not wind the air hose too tightly.
• Do not apply force when folding or bending the cuff.
• To separate the cuff from the main device, please do not pull
the air hose, but grip the air connector and gently pull it off.
• If the device was stored at temperatures below 0°C, allow
it to stand at room temperature for at least 1 hour before
using it.
• If the device is not to be operated for an extended period of
time, please remove the batteries. Store the batteries out of
the reach of children.
EN-62

Maintaining the device

Warranty

The device has been manufactured and tested with all due care.
Nevertheless, in the event of defects upon delivery, we provide a
warranty under the following conditions:
During the warranty period of 3 years from the date of pur-
chase, we remedy such defects at our discretion and at our ex-
pense in our plant through repair work or replacement delivery
of a defect-free device.
The warranty does not cover normal wear and tear of wearing
parts or damage caused by failure to observe the instructions
for use, improper handling (e.g. unsuitable power sources,
breakage, leaking batteries) and/or disassembly of the device
by the buyer. Furthermore, the warranty does not constitute
grounds for asserting claims for damages against us.
Warranty claims can only be asserted during the warranty peri-
od and upon presentation of the proof of purchase. In the case
of a warranty claim, the device along with the proof of purchase
and a description of the complaint must be sent to:
UEBE Medical GmbH
Service-Center
Zum Ottersberg 9
97877 Wertheim, Germany
The cost of returning the device to our factory shall be borne by
the sender. Complaints that are sent back without prepayment
will not be accepted by UEBE.
The statutory claims and rights of the buyer against the seller
(for example, defect claims, producer liability) are not restricted
by this warranty.
Please note: In the case of a warranty claim, please make sure
to enclose the proof of purchase.
G
EN-63