Publicité
Les langues disponibles
Les langues disponibles
WARNING
WARNING MESSAGE TO INSTALLERS AND MAINTENANCE PERSONNEL OF HORN-LIGHT
People's lives depend on your safe installation of our products. It is important to follow all instructions shipped
with the products. This device is to be installed by a trained electrician who is thoroughly familiar with the
National Electrical Code and will follow the NEC Guidelines as well as local codes.
The selection of the mounting location for the device, its controls and the routing of the wiring is to be
accomplished under the direction of the Facilities Engineer and the Safety Engineer. In addition, listed below are
some other important safety instructions and precautions you should follow:
•
Read and understand all instructions before installing or operating this equipment.
•
Failure to follow all safety precautions and instructions may result in property damage or serious injury to
you or others.
•
This unit should be installed by a qualified electrician in accordance with local electrical and fire codes.
•
If the unit is not installed in a supervisory system, it must be tested at regular intervals. Refer to local fire
codes for this information.
•
After installation, test the light system to ensure that it is operating properly.
•
After testing is complete, provide a copy of this instruction sheet to all operating and servicing personnel.
•
Disconnect power before any installations are made.
•
Establish a procedure to routinely check the light system for proper activation and operation.
•
Any maintenance to the light system must be performed by a trained electrician in accordance with NEC
Guidelines and local codes.
•
The nameplate, which may contain cautionary or other information of importance to maintenance personnel,
should NOT be obscured in any way. Ensure that the nameplate remains readable when the housing's exterior
is painted.
INSTALLATION INSTRUCTIONS FOR STROBE LIGHT ON HORNS AND SPEAKERS
A. Introduction.
This sheet provides the user with instructions for the installation of Strobe Warning Lights on horns and
speakers. All instructions assume that mounting provisions have been completed and electrical power has
been routed to the installation site.
The warning light can be weatherproofed by installing the supplied gasket (refer to
paragraph E). Also the audible signal or adapter plate should be weatherproofed by using
the proper electrical box.
High voltages may be present inside the light assembly even though power is not connected.
If access to the component board is required (removal or replacement), the capacitor must be
discharged by touching a wire to both ends of the Flashtube. Do not attempt to touch or move
B. Installation on Adapter Plate.
• Refer to "Warning Message to Installers" packed with this unit. Also, refer to Introduction and Basic
Installation instructions in this instruction sheet before installing device.
• Use only 14 to 18 AWG wire for power connection. Strip no more than 0.25-inch of wire insulation from the
ends of the power leads.
1. Insert bushing (supplied) into adapter plate. Route power leads through the slot in the BCL or SFL
Adaptor Plate, as shown in figure 1. Snap the front cover of the light off. Route power leads through
board assembly as shown in figure 2. Connect the power leads to the terminals of the two position
connector by inserting the stripped ends of the wire into the connector as far as they can travel, polarity
MUST be observed on DC units. Make sure supply lead insulation is flush with connector. If stranded
SYSTEMS
WARNING
the assembly until the capacitor has been discharged.
WARNING
-1-
MESSAGE
Publicité
