Metabo HPT CJ 90VST2 Instructions De Sécurité Et Mode D'emploi page 10

English
Insert the splinter guard in the space on the base, and
push it completely. (Fig. 8)
Splinter
guard
Blade
12. Sub base (Sold separately)
Used for curved cutting of pieces such as arcs and
circles. Makes the task easier by eliminating any
snags that may occur between the rear of the base
and the material.
Fit into position after hooking the sub base to the tip
of the base. (Fig. 9)
To detach, pull up.
NOTE
When the sub base is attached, the blade's protrusion
from the material being cut will be reduced by 3 mm.
When the blade has been moved down to the lowest
point, check to make sure that it is protruding from the
material.
10
Base
Fig. 8
Sub base
Base
Fig. 9
13. Base plate
Unscrew the four screws on the base to enable the
base plate to be removed.
Retighten the four screws securely after reattaching.
(Fig. 10)
Unscrew four
screws
14. Prepare a work bench (Fig. 11)
Since the blade will extend beyond the lower surface
of the material, place the material on a work bench
when cutting. If a square block is utilized as a work
bench, select level ground to ensure it is properly
stabilized. An unstable work bench will result in
hazardous operation.
Lumber
Work bench
CAUTION
To avoid possible accident, always ensure that
the portion of material remaining after cutting is
securely anchored or held in position.
Base plate
Base
Fig. 10
Base
Blade
Fig. 11