Atlantic Muraux DOJO Notice D'installation Et D'utilisation page 41

In AUTO mode
The unit operates in the sleep mode adapted to the automatically selected operation mode.
In FAN mode
SLEEP mode is unavailable in FAN mode
• When quiet sleep function is set to 8 hours the quiet sleep time cannot be adjusted.
• When TIMER function is set, the quiet sleep function cannot be set.
• After the SLEEP function is set, if the user resets TIMER function, the SLEEP function is canceled;
the machine is in the state of timing-on, if the two modes are set at the same time, either of their
operation times is ended first, the unit stops automatically, and the other mode is canceled.
•
After a power failure:
Press the sleep button ten times in five seconds and enter function after hearing
four sounds. And press the sleep button ten times within five seconds and leave
this function after hearing two sounds.
• Power Failure Resume Function
If the unit is started for the first time, the compressor will not start running unless 3
minutes have elapsed. When the power resumes after power failure, the unit will
run automatically, and 3 minutes later the compressor starts running
4.3. Healthy airflow Operation
Press to start.
The HEALTHY AIRFLOW operation set comfort operation conditions.
To set the healthy airflow function
1. Press the EXTRA FUNCTION button
2.
Press this button continuously, the orientation of the louvers goes through the 3 positions (See
the following illustration).
3.
Select a swing orientation, and then press the CONFIRM/CANCEL
To cancel the healthy airflow function
1. Press the EXTRA FUNCTION button
2. Press this button continuously, the orientation of the louvers goes through the 3 positions (See
the following illustration).
3. Press CONFIRM/CANCEL
• Avoid adjusting the flap by hand. It could cause the grille to function incorrectly.
• If the grille functions incorrectly, stop the unit for a minute and start it again with the
remote controller.
• After setting the healthy airflow function, the position of the grilles cannot be changed.
•
In cooling, it is better to select the
to enter additional options.
FONCTION +
to enter additional options.
FONCTION +
button to cancel.
mode.
button to confirm.
41