Beyerdynamic Synexis TS8 Notice D'utilisation page 5

How to operate the transmitter
1. Connect the supplied antenna to the antenna output
2. Connect the XLR input
dynamic microphone.
3. Set the sensitivity according to the input level.
Recommendation:
Mic when using dynamic microphones
Line when using interpretation systems, mixing console outputs etc.
4. Depending on the application you can connect an MP3 or CD player to the AUX input
5. Make sure the mains voltage shown on the power adapter corresponds to the local mains voltage.
6. Connect the power adapter to the receiver and to AC power.
7. Switch on the Synexis TS8
8. Channel and AF level are displayed
until the requested channel is displayed
to lock the selected channel to avoid accidental shifting, hold down the Set button
symbol will be displayed
Set button for about 3 seconds. The key symbol in the display
9. To display the frequency, press the Set button
10. If the transmitter is not operated for a while, the display turns into a "screensaver" mode (dimmed, continuous
display). The AF level is not displayed in the "screensaver" mode. In order to activate it, press briefly the Set
button .
11. To avoid accidental pulling off the power adapter cable, thread the power cable through the cable grip as shown
on the illustrations below.
or the jack input to the output of a mixing console, interpretation system or a
.
. If you wish to select a different channel, press the up or down button
. Release the button
. The channel is locked. If you would like to unlock a locked channel, hold down the
briefly. The frequency is displayed next to the channel.
cable grip
.
to store the selected channel. If you would like
will disappear.
.
for about 3 seconds. A key