Advanced Crossover Setup - Alpine SPX-13PRO Manuel De L'utilisateur

Speaker Locations Speaker Configurations
Points to Observe for Safe Usage
INSTALL
MODULE 1
A
Driver side
network
NOTE: TW LEVEL adjustment may be desired. See Advanced Settings Matrix
for recommendations (Page 10).
Advanced Crossover Setup
Advanced Settings Procedure
Step 1: Estimate the listening angle from the woofer to the head location at the main listening
position. Repeat this for the tweeter. Use these angles and the ON & OFF Axis
Definitions (page 9) to determine if the woofer and tweeter are ON or OFF axis.
Step 2: Measure the distance from the woofer to the head position at the main listening
position. Repeat this for the tweeter. Subtract these distances to find difference.
Step 3: Using the results obtained from Step 1 & Step 2, choose the appropriate Phase Link
Module(s). For greater accuracy, please refer to the Advanced Settings Matrix
(page 10).
Step 4: Adjust the tweeter level for each network.
NOTE: Tweeter level adjustment may be required for:
1. Proper level matching based upon listener position
2. Satisfying the tastes of the listener.
Refer to the Advanced Settings Matrix (page 10) for recommendations.
The use of different Phase Link Modules for left/right channels is intended to optimize
imaging for the primary listening position. If equal performance is desired for all
seats, use the near side measurement as reference for both networks.

-EN
Type F
B
INSTALL
MODULE 1
A
Passenger side
network
B