Crossover Setup; Speaker Locations - Alpine SPX-13PRO Manuel De L'utilisateur

Crossover Setup
Basic Procedure
Step 1: Refer to the speaker configurations shown on pages 5-8 for the most common speaker
locations.
Step 2: Pick the speaker location type (e.g. Type A, Type B, etc.) that best matches your system.
Step 3: Install the recommended Phase Link Module in each network.
Step 4: Adjust the tweeter level for each network.
NOTE: Tweeter level adjustment may be required for:
1. Proper level matching based upon listener position
2. Satisfying the tastes of the listener.
Refer to the Advanced Settings Matrix (page 10) for recommendations.
The use of different Phase Link Modules for left/right channels is intended to
optimize imaging for the primary listening position. If equal performance is desired
for all seats, use the near side measurement as reference for both networks.
Speaker Locations
Points to Observe for Safe Usage
INSTALL
MODULE 2
A
Driver side
network
B
NOTE: TW LEVEL adjustment may be desired. See Advanced Settings
Matrix for recommendations (Page 10).
Type A
or
or or
INSTALL
MODULE 2
A
Passenger side
network
B

-EN