Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Install the Coffee System
WARNING
Excessive Weight Hazard
Use two or more people to move and install the built-in
coffee system.
Failure to do so can result in back or other injury.
1. Pull the runners forward until they are fully extended and in
the locked position.
2. Using 2 or more people, position the coffee system onto
the runners, making sure that the 4 pins of the L-brackets fit
securely inside the holes on the bottom of the coffee system.
3. Secure the coffee system to the runners with the four
3/16" x 3/8" (4.2 x 9.5 mm) screws.
4. Position the power supply cord clip on the top of the cabinet,
approximately 13ZZ/zn" (34.8 cm) from the front of the cabinet
and centered from left to right. With a pencil, mark the hole
through the clip on the top of the cabinet.
5. Using a 1/16" (2 mm) drill, drill the hole marked in Step 4.
6. Using one 3/16" x 5/8" (4.5 x 16 mm) screw, attach the
power supply cord clip to the top of the cabinet.
A. Power supply cord clip
B. Power supply cord
6
7. Secure the power supply cord with the power supply cord
8. Plug the coffee system into a grounded 3-prong outlet.
9. Push the coffee system back into the housing.
10. Proceed to "Complete Installation" section.
1. Prepare your coffee system for use by following the
2. If the coffee system does not operate:
Installation is now complete.
A
B
Save these Installation Instructions for future use.
If you need Assistance or Service:
Please reference the "Assistance or Service" section of the
Use and Care Guide, or contact the dealer from whom you
purchased your coffee system.
Approx. 13¹¹/₁₆"
(34.8 cm)
clip. Make sure there is enough slack in the power supply
cord to allow the coffee system to be pulled completely from
the cabinet in order to fill the coffee bean container.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
Complete Installation
directions in "Before Using the Coffee System" in the Use
and Care Guide. Then test the coffee system by using one of
the coffee system functions.
Check that a household fuse has not blown, or a circuit
■
breaker tripped. Replace the fuse or reset the circuit
breaker. If the problem continues, call an electrician.
Check that the power supply cord is plugged into a
■
grounded 3 prong outlet.
See the Use and Care Guide for troubleshooting
■
information.
Publicité
Table des Matières
