Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
WARNING
Excessive Weight Hazard
Use two or more people to move and install the built-in
coffee system.
Failure to do so can result in back or other injury.
1. Pull the runners forward until they are fully extended.
2. Using 2 or more people, position the coffee system onto the
runners, making sure that the 2 hooks on the back of the
mounting brackets are inside the holes on the rear/back/
bottom of the coffee system. Pull runners all the way forward
and in the locked position.
NOTE: There is a white 'dial' on the front of the runners that
can be rotated for minor height adjustments. Lock coffee
system into place using the 'orange locking tabs'.
A
A. Orange locking tabs
3. Secure the coffee system to the runners with the two
3/16" x 3/8" (4.2 x 9.5 mm) screws.
4. Position the power supply cord clip on the top of the cabinet,
approximately 13ZZ/zn" (34.8 cm) from the front of the cabinet
and centered from left to right. With a pencil, mark the hole
through the clip on the top of the cabinet.
6
Install the Coffee System
5. Using a 1/16" (2 mm) drill, drill the hole marked in Step 4.
6. Using one 3/16" x 5/8" (4.5 x 16 mm) screw, attach the
7. Secure the power supply cord with the power supply cord
8. Plug the coffee system into a grounded 3-prong outlet.
9. Push the coffee system back into the housing.
10. Proceed to "Complete Installation" section.
power supply cord clip to the top of the cabinet.
A. Power supply cord clip
B. Power supply cord
clip. Make sure there is enough slack in the power supply
cord to allow the coffee system to be pulled completely from
the cabinet in order to fill the coffee bean container.
WARNING
Electrical Shock Hazard
Plug into a grounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in death,
fire, or electrical shock.
A
B
Approx. 13¹¹/₁₆"
(34.8 cm)
Publicité
Table des Matières
