Publicité
Les langues disponibles
Les langues disponibles
2. Technical Specifications
Power supply: AC 230V~50Hz
Power consumption：75W
Light source: 75W xenon lamp
Weight：1.35 kg
3. How to set the unit
Manual control mode:
To control the strobe in manual control mode, simply plug the unit into an appropriate
mains power supply. Then use the flash speed control knob on the rear of the unit to set
the desired flash speed. The unit will now strobe to the set flash speed.
Remote control mode:
To control the strobe in remote control mode, first plug external remote controller into an
appropriate mains power supply. Then plug one end of the 1/4" mono jack cable (signal) into
the "INPUT" Jack socket on the rear of the unit. Now plug the opposite end of the 1/4"
(6.35mm) mono jack cable (signal) into the "OUTPUT" socket on the remote controller.
Please be sure to set all of the manual control knobs to the off position and refer to the
strobe controller user manual for operation.
If you wish to connect a second strobe, first plug the 1/4" (6.35mm)mono jack signal cable
into the "OUTPUT" socket on the first (master) unit. Now plug the opposite end of the 1/4"
mono jack signal cable to the "INPUT" socket on the second (slave) unit.
To link further units together in a daisy chain fashion, repeat the above step and so on.
4
Publicité
