Tv Tuner Control; Selecting Preset Channel; Seeking Channel Manually; Memorizing Channel - Alpine PKG-RSE1 Mode D'emploi

TV Tuner Control

To control TV tuner from the Front Panel Controls, set
source name to TV in the System Setup.
• Refer to ALPINE TV Tuner Operation Manual for
details.

Selecting Preset Channel

▲ ▼
Press CH or CH
memorized by SCAN on the remote control or ENT
on the Front Panel Controls.

Seeking Channel Manually

Press or to seek Channel manually.
Channel moves UP or DOWN one by one.
Press and Hold
and stop when next higher or lower available CH
is found.

Memorizing Channel

Press SCAN on the remote control or ENT on the
Front Panel Controls to memorize the receivable
channels in the entire TV broadcast band.
TW_PKG-RSE.indb EN11 TW_PKG-RSE.indb EN11
ENT
Front Panel Controls
Remote Control
to select preset channel
or , Channel Seek will start

Wireless Headphone

Headphone Receivers

L
1
2
5
4
3
1) Infrared Sensors; Receive signal from the
transmitter.
2) Battery Cover
3) Volume Control
4) Power Switch
5) Power Indicator LED

Operation

Read carefully to prevent damage to the
headphone or your ears:
WARNING: Before turning on the power, remove
headphones and turn the volume down as low as possible.
1) Be sure the batteries are properly installed in the
headphones.
2) Turn the headphones volume completely down
before placing it on your ears and turning on the
power.
3) Turn on the headphone power and adjust the
headphone volume to a comfortable level (You can
increase the audio source volume if needed).

Battery Installation

Place two AAA batteries into the battery compartment of
the headphone(s), making sure that the battery polarity is
correct.
R
11
-EN
4/25/05 4:51:30 PM 4/25/05 4:51:30 PM