Publicité
Les langues disponibles
Les langues disponibles
Switching ON and OFF
Short-time operation
ON:
Press the ON/OFF switch
OFF:
Release the ON/OFF switch
Long-time operation
ON:
Keeping the ON/OFF switch pressed, push in the arrestor button.
OFF:
Press and release the ON/OFF switch again.
Attention!
Use the arrestor button only during operation with drill rig. Its
!
use during manual operation is not allowed.
If the machine stops for any reason or due to power failure,
immediately release the arrestor button by pressing the ON/OFF
switch.
The EHD 1500 is equipped with an electronic switch. With this switch
the speed can be regulated according to the pressure on the button.
Only use the electronic switch when you want to start or stop the
machine in order to avoid material splashing around. A permanent
use with reduced speed can cause an overload because the motor
then gets less cooling air and therefore the machine will be
overheated much faster.
The EHD 1500 is equipt with a spindle connection M18.
For drill bits with M16 male threads, an adapter (Order Number 35512) is
available as add-ons.
The EHD 1500 is equipt with a dust extraction for drill bits M16 (Order
Number: 35472, 35474, 35475, 35476)
Make sure that the diamond segments have sufficient cutting clearance
towards the bit body.
Changing Drill Bits
Attention!
When you use or sharpen the machine, it might heat up enormously.
You could burn your hands or get cut or ripped by the segments.
Therefore, always use protective gloves when changing the drill bit.
Drill Bits
16
Publicité
