SEVERIN KGK 8978 Mode D'emploi page 27

b) Remove the screws from the stopper, as
shown in the following figure, and install it
on the opposite side of the door.
c) Remove the shaft and the two stoppers
from the lower hinge and install it in the
position, as shown in the following figure.
Install the refrigerator and freezer doors on the
opposite side.
a) Remove the adjustable stand in the front,
as shown below. Then, install the lower
hinge on the other side of the fridge and
tighten the screws.
b) Install the shorter adjustable stand in the
front on the side, where the lower hinge is.
By turning the stand, you can adjust the
height on this side of the appliance until it
is levelled out.
a) Attach the freezer door, turn the mid-
dle hinge 180° and then install it on the
opposite side of the appliance. Attach the
middle hinge with the 3 corresponding
screws.
Step 4
b) Attach the refrigerator door and install the
upper hinge on the opposite side of the
appliance. Attach the upper hinge with the
4 corresponding screws. Attach the upper
hinge cover with a screw.
c) Install the gap cover on the opposite side
of the appliance and tighten the screw.
Finally, check for the right alignment of the
doors and that they close properly on all
sides. If necessary, adjust the stands in the
front for a fully horizontal positioning of the
appliance.
If you have tilted the appliance by more than
30°, please wait 4 hours before you connect
the appliance to the mains supply.
- 27 -
Step 5