Preparing A Power Source (Dry Battery); Checking The Remaining Power Of The Battery - Sony Walkman D-NE520 Mode D'emploi

Preparing a Power
Source
(Dry Battery)
Use only the following dry battery type for
your player.
• LR6 (size AA) alkaline battery
(not supplied)
1
Squeeze the OPEN switch from both
sides to open the lid of your player.
2
Open the battery compartment lid
inside the player.
Raise
Battery
compart-
ment lid
3
Insert the battery by matching the
 to the diagram in the battery
compartment and close the lid until
it clicks into place.
OPEN switch
Press
Insert the
 end first.
To remove the battery
Remove the battery as illustrated below.
To attach the battery compartment lid
If the battery compartment lid is detached
by an accidental drop, excessive force, etc.,
attach it as illustrated below.
Checking the remaining
power of the battery
The remaining power of the battery is
indicated in the display as shown below. As
the black indicator section decreases, the
remaining power is depleted further.
 
 "Low Battery" *
* Beep sounds.
When the battery is depleted, replace it with
a new one.
Notes
• The display shows the approximate battery power
remaining. For example, one section does not
always indicate one-fourth of the battery power.
• Depending on the operating conditions, the display
may increase or decrease relative to the actual
power remaining.
 
Continued 
11
GB