DeWalt D25413 Guide D'utilisation page 12

2. Drill straight, keeping the bit at a right angle to the work. Do not
exert side pressure on the bit when drilling as this will cause
clogging of the bit flutes and a slower drilling speed.
3. When drilling deep holes, if the hammer speed starts to drop off,
pull the bit partially out of the hole with the tool still running to help
clear debris from the hole.
4. For masonry, use carbide-tipped bits or masonry bits. A smooth
even flow of dust indicates the proper drilling rate.
Chipping and Chiselling (Fig. 1)
1. Set the mode selector switch (G) to the hammering only position.
2. Insert the appropriate chisel and rotate it by hand to lock it.
3. Adjust the side handle (C) as required.
4. Be sure chisel is in contact with work surface before depressing
the trigger switch.
5. Always fully release the trigger switch when work is finished and
before unplugging.
MAINTENANCE
WARNING: To reduce the risk of injury, turn unit off
and disconnect it from power source before installing and
removing accessories, before adjusting or when making
repairs. An accidental start-up can cause injury.
Motor Brushes
D WALT uses an advanced brush system which automatically stops
E
the drill when the brushes wear out. This prevents serious damage
to the motor. New brush assemblies are available at authorized
D WALT service centers. Always use identical replacement parts.
E
Cleaning
WARNING: Blow dirt and dust out of all air vents with clean, dry air
at least once a week. To minimize the risk of eye injury, always wear
ANSI Z87.1 approved eye protection when performing this.
WARNING: Never use solvents or other harsh chemicals for
cleaning the non-metallic parts of the tool. These chemicals may
weaken the plastic materials used in these parts. Use a cloth
dampened only with water and mild soap. Never let any liquid get
inside the tool; never immerse any part of the tool into a liquid.
Accessories
WARNING: Since accessories, other than those offered by
D WALT, have not been tested with this product, use of such
E
accessories with this tool could be hazardous. To reduce the risk of
injury, only D WALT recommended accessories should be used with
E
this product.
Recommended accessories for use with your tool are available at
extra cost from your local dealer or authorized service center. If you
need assistance in locating any accessory, please contact D
Industrial Tool Co., 701 East Joppa Road, Baltimore, MD 21286,
call 1-800-4-D WALT (1-800-433-9258) or visit our website: www.
E
dewalt.com.
MAXIMUM RECOMMENDED CAPACITIES
Maximum Capacity
R.P.M.
BITS, Metal Drilling
Wood, Flat Boring
Optimum Capacity
No-load BPM
10
WALT
E
1-1/8" (28.5 mm) Concrete
0–820 (No Load)
1/2" (13 mm)
1-1/8" (28.5 mm)
1/2" - 1" (13 to 25 mm) Concrete
0-4,700