Camera Start-Up - ACME Flash Back Movie Manuel D'utilisation

Flash Back Movie
Trimming/Adjust
If the helicopter turns around its own shaft, you have to adjust this effect by turning the
trimming wheel. The left trimming wheel has no function!

Camera Start-Up

Please connect the battery directly on the plug of the board.
Charge the LiPo battery of the camera with the USB- Cable connecting to your computer.
Insert a micro SD- Card (up to 8GB, not included) into the slot. The memory card should offer
a writing speed of minimum 4MB/Sec., in order to avoid bad recordings.
Adjust the camera head for optimal recording.
Turn On the cam using the switch.
Modes
The different modes get displayed by the LED – the color shows the action.
Stand-By
LED green, permanent light
Video
LED flashes green, flash frequency1x/Sec.
Serial
Photo
LED flashes green, slow flash frequency
Photo
1x/2 Sec.
To Start/Stop recording of the chosen mode, activate the free channel on your TX/RX (Switch
on and off immediately).
To switch the mode, hold for 3 seconds.
You can also change the mode by pressing the small white button on the board of the
camera.
Read the recorded data
You have the following possibilities to read out videos and photos:
1. Connect the cam to the computer
2. Insert the micro SD- Card to a card reader or SD- Adaptor
We recommend the free Video player „VLC-Player"to watch the videos.
Download at http://www.videolan.org/vlc
Technical Data
Resolution: VGA 720x480 Pixel
USB: 1.1 Mini USB
FPS: 30/Sec.
Focus: 0,3m
Weight: 16g
Micro-SD-CARD: max. 8GB
Modes: Video, Serial Photo, Photo
Recording
LED red, permanent light
LED flashes red,
flash frequency 1x/Sec.
LED flashes red once for
every shot