Beta 1438K/DSG Mode D'emploi page 14

INSTRUCTIONS FOR USE ISTRUZIONI PER L'USO
DISASSEMBLY OF THE CLUTCH ENGAGEMENT SYSTEM
- Remove the small thrust bearing (for K2).
- Remove the big thrust bearing (for K1).
Warning: indicative instructions – always refer to the instructions provided by the parent
company/ manufacturer.
ASSEMBLY AND ADJUSTMENT OF THE CLUTCH ENGAGEMENT SYSTEM
Assemble the new components, always closely adhering to the instructions provided by the parent
company/manufacturer. Then measure and adjust the clutch engagement system using the
adjustment gauge C.
Warning: with regard to the entire process involved in the installation, measurement
and adjustment of the clutch engagement system, always refer to the instructions
provided by the parent company/manufacturer.
DUAL CLUTCH ASSEMBLY
- Fit the new clutch unit on the main outer shaft. Make sure the main outer shaft properly couples
with the gear teeth of the clutch disc (K2).
Warning: always refer to the instructions provided by the parent company/manufacturer.
- Place thrust bushing D on the internal central ring of the clutch unit bearing.
- Assemble cross member A securing it properly to the clutch casing.
Make sure the cross member and the thrust bushing work perpendicular to the clutch casing bell.
- Turn the cross member's drive screw and keep pressing the thrust bushing until you can see
the safety ring's seat.
Warning: lubricate the drive screw and press it only as much as necessary to avoid
damage to the main outer shaft support and the gearbox.
- Remove both the cross member and the thrust bushing.
- Fit the new safety ring.
Refer to the instructions provided by the parent company/manufacturer for the correct assembly steps
of the new safety ring.
14
EN I